Installing the ZoneAlarm Router

To install the ZoneAlarm router

1. Verify that you have the correct cable type.

   For information, see Network Requirements.

2. Connect the LAN cable:
   • Connect one end of the Ethernet cable to one of the LAN ports at the back of the unit.
   • Connect the other end to PCs, hubs, or other network devices.
3. Connect the WAN cable:
   • Connect one end of the Ethernet cable to the WAN port at the back of the unit.
   • Connect the other end of the cable to a cable modem, DSL modem, or office network.
4. Connect the power supply to the power socket, labeled PWR, at the back of the ZoneAlarm router.
5. Plug the power supply into the wall electrical outlet.

   Warning: The ZoneAlarm router power supply is compatible with either 100, 120 or 230 VAC input power. Verify that the wall outlet voltage is compatible with the voltage specified on your power supply. Failure to observe this warning may result in injuries or damage to equipment.

Typical Connection Diagram