Wall Mounting the ZoneAlarm Router

For your convenience, the ZoneAlarm router includes a wall mounting kit, which consists of two plastic conical anchors and two cross-head screws.

To mount the ZoneAlarm router on the wall

1. Decide where you want to mount your ZoneAlarm router.
2. Decide on the mounting orientation.

   You can mount the router on the wall facing up, down, left, or right.

   Note: Mounting the router with the ports facing upwards is not recommended, as dust might accumulate in unused ports.

3. Mark two drill holes on the wall, in accordance with the following sketch:

   

4. Drill two 3.5 mm diameter holes, approximately 25 mm deep.
5. Insert two plastic conical anchors into the holes.

   Note: The conical anchors you received with your ZoneAlarm router are suitable for concrete walls. If you want to mount the router on a plaster wall, you must use anchors that are suitable for plaster walls.

6. Insert the two screws you received with your ZoneAlarm router into the plastic conical anchors, and turn them until they protrude approximately 5 mm from the wall.
7. Align the holes on the ZoneAlarm router's underside with the screws on the wall, then push the router in and down.

   Your ZoneAlarm router is wall mounted. You can now connect it to your computer.